Installation Of A Lens - Barco XDX Series Installation Manual

Image 4–10
2 UPS Power cord
3 Cable gland
4 Protected Earth (PE) wire
5 Power wires L and N
Tip: Check for good fixation by pulling on each wire.
5. Secure the AC power cord by fastening the cable gland (reference 3). Use a 24 mm open-end wrench.
6. Place the net input cover back and seal it. Tighten the two screws (reference 1), using a T20 Torx
screwdriver.

4.5 Installation of a lens

How to install a lens into the B-lens holder, while using the optical adapter
1. Place the lens holder in the "unlocked" position. Do this by pulling the lens lock handle (reference 1,
Image 4–11) outward and then towards the lens power supply socket (reference 2) as illustrated.
2
Image 4–11 Lens installation, preparing the lens holder
2. Remove the dust cover from the lens opening.
1
Installation procedures
R5914481 /02 XDX 47