Step 9A Install Overlay Panels - Monogram ZIRP360NXARH Installation Instructions Manual

Installation Instructions
STEP 9A INSTALL OVERLAY PANELS
Right hand models shown. Use the same instructions
for left hand models.
Use Front Holes
to Secure Handle
UseRearHoles
to SecureTrim
Move
Forward
For3/4"
Panel
Handle
Trim
Door T rim
Door
Install Door Panel:
• Open the door to 90 °. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the overlay panel into the door trim.
Supplied h andle shown
intheoverlay panel p osition.
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the REARscrew holes.
• Secure the handle to the door using the FRONT
screw holes.
Custom Handles
If you are using custom handles, the handle must
be properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door trim using new handle side trim.
Discard the supplied handle.
19