Step 5, Level Unit - Monogram ZIRP360NXARH Installation Instructions Manual

Installation Instructions
STEP 5 LEVEL UNIT
All models have 4-point leveling. The front is supported
bu leveling legs; the rear is supported bu adjustable
wheels. Both are accessible from the front of the unit.
• To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise
to raise or counterclockwise to lower the unit.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of unit to match installation cutout
opening 83-1/2 to 8/4-1/2". The unit should be level
and plumb with cabinetry.
J
Hex NutAdjusts - -!_u_===_=_, i
RearWheels /1_11 I
J LevellngLeg "_
-&CAUTION:
The rear leveling wheels and front leveling legs
ore limited to a maximum height adjustment of 1".
If the installation requires more than 8/4-1/2" height,
the installer should elevate the unit on a sheet
of pluwood or runners. Cabinetru trim could also
be added across the top of the opening to shorten
the opening. If you attempt to raise the unit more
than 1", you will damage the front leveling legs
and the rear leveling wheels.
-&PRUDENCE
Les roues de nivellement arri@reetles pattes de
nivellement event permettent un r@glagemaximal
de 25 mm (1 po). Si I'ouverture pour I'apporeil
m@noger a une hauteur sup@rieure_ 2,15 m
(8/4-1/2 po), I'installateur doit @leverI'appareil m@nager
surune feuille de contre-plaqu@ ou des glissi@res.
II est @golement possible d'ajouter des baguettes
de finition des placards sur le haut de I'ouverture
afin de la r@duire.Lever I'appareil m@nager de plus
de 25 mm (1 po) endommage les pattes de nivellement
event etles roues de nivellement arri@re.
15