Frameless Cabinets; Accessory Panel Kits - GE Monogram ZIS36N Custom Options Manual And Installation Instructions

Design Information
36" Built-In Refrigerators
Installation Examples
Side panels are required whenever the sides of the refrigera-
tor will be exposed.
1/2" to 3/4" side panels are normally set into place and
fastened to adjacent cabinetry or to the back wall before
rolling the refrigerator into the opening.
Therefore, the rough-in dimensions must allow for side panel
thickness. In both a flush and semi-flush installation, the
finished dimension, (the width of the opening after side panels
are installed), must accommodate the full width of the
refrigerator.
See page 14for side panel sizes.
Installa tion
Between
Base &
Wall Cabinets
Installation
At End-of-Run
Flush and Semi-Flush
Installations
[_ 1/4" Thick _J
Side Panels
Finished Dim. _35q/2'_
Roughedqn Dim., 36'_
Note: 1/4" thick side panels can be
inserted into the case trim, making the
rough-in the same as the outside trim
width, 36".
cRefrigerator_
Cabinet
1/4" Side Panels. Insert end of
side panel into trim
Flush and Semi-Flush
Installations
l lJ2"Thick II I
36"_ Finished Dim.
3T'_ Rough-In Dim.
Note: 1/2" thick side panels shown. Side panels can
be any thickness. Add side panel thickness to outside
trim width (36") to calculate the rough-in dimension.
The leading (front) edge must be finished to match
surrounding cabinetry.
I
Reffigerator_
Cabinet_
_ Refrigerator door _
/
Cabinet
1/2" To 3/4" Side Panels.Leading
EdgeFlush With Cabinet
Frameless
Cabinets
Side panels, 1/2" minimum thickness are
required when using frameless cabinets.
The side panel acts as a spacer between the
cabinet and the case trim and prevents
interference with cabinet door swing. The
leading (front) edge must be finished to
match surrounding cabinetry.
1/2" To 3/4" Side Panels.Leading
EdgeFlush With Cabinet
Accessory
Panel Kits
Field installed door and grille panels are required. The factory
installed trim will accept accessory panel kits. White or black
Lexan k and stainless steel kits are available. Panels are cutto
size and ready to install. These panel kits must be ordered
separately.
Model Black White Stainless
ZlS36N ZWBP36 ZWWP36 ZWSP36
ZlSW36D ZWWP36D ZWSP36D
ZlSB36D ZWBP36D ZWSP36D
A wide range of custom appearance options can be created
with optional custom trim kits. See the opposite page for
examples and trim kit descriptions.