Figure 2-16, Multiple Connections To Dc Ground Rod (Method 1); Table 2-4, Ac Grounding Electrode Conductor Sizing - Magnum Energy RD Series Owner's Manual

Modified sine wave inverter/chargers
Hide thumbs Also See for RD Series:
Table of Contents

Advertisement

Installation
2.6.1
Sizing the Grounding Electrode Conductors
AC Side - The size of the AC Grounding Electrode Conductor (GEC –AC) depends on the size of
the largest ungrounded conductor feeding the AC load center. One #8 AWG (8.4 mm
conductor will serve as an AC Grounding Electrode Conductor (GEC –AC) for AC power conductors
smaller than and including #2 AWG (33.6 mm

Table 2-4, AC Grounding Electrode Conductor Sizing

Size of Largest Ungrounded
#2 AWG or smaller
#2/0 or #3/0 AWG
through 350 kcmil
DC Side - To size the DC grounding electrode conductor, you must fi rst determine which one of the
following three methods will be used to connect the DC and AC grounding points in the inverter's
two electrical systems to the common "earth" ground:
Method 1 (see Figure 2-16): This method uses a separate grounding electrode for the DC system
and the AC system. In this method — since there are multiple connections to the DC Grounding
Electrode (GEC – DC) — the size of the DC grounding electrode conductor cannot be smaller than
the largest conductor in the DC system (usually the battery-to-inverter cable).
The DC Grounding Electrode (GE – DC) must be bonded to the AC Grounding Electrode (GE – AC)
to make a grounding electrode system; this bonding conductor (BC) cannot be smaller than the
largest grounding electrode conductor, either AC or DC.
A C S e rvice
G B B

Figure 2-16, Multiple Connections to DC Ground Rod (Method 1)

Page 29
Conductor
#1 to #1/0 AWG
Over #3/0 AWG
A C E lec tric al S y s tem
R D S e rie s In ve rte r/ C h a rg e r
P a n e l
H ot
A C
N e u tra l
G C
N eutr al
S B J
AC G r ound
E G C - A C
G E C -A C
G E
Grounding Electrode
(AC side dedicated )
) copper. See Table 2-4 for additional values.
2
Minimum Size of Grounding
Electrode Conductor
(8.4 mm
#8 AWG
(13.3 mm
#6 AWG
(21.1 mm
#4 AWG
(33.6 mm
#2 AWG
D C E lec tric al S y s tem
Positive
D C
G C
N egative
D C G r ound
E G C - D C
G rounding
G E C -D C
S y s tem
G E
B C
Grounding Electrode
(D C side dedicated)
) copper
2
)
2
)
2
)
2
)
2
D C S e rvice
P a n e l
N e g a tive
S B J
G B B
© 2010 Magnum Energy, Inc

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rd2212Rd1824Rd2824Rd3924

Table of Contents