WisyCom MTK952 User Manual page 11

rev.02 MTK952 User Manual
TX on air at startup
This menu allows to decide if turn ON or turn OFF the RF power of the transmitter while the
MTK952 is powering on.
If set to No: while the MTK952 is powering on, the RF output remains mute. The Status Screen on
the display shows "TX OFF " and the set Group, Channel and frequency.
NOTE: When the RF power of the transmitter is OFF, all the led and the bars remain turned off.
Pushing the rotatory knob (at the right of the display) it is possible to activate the led and bars
(keeping the RF power OFF) and enter on the menu.
If set to Yes: during the MTK952 power on, the progress bar appears for 10 seconds.
TX power
This menu allows to set the power of the transmitter. Rotating the knob it is possible to change
current TX power setting among 10/20/50/100/200 mW (2W only for MTK952 with 2W option).
Push the SAVE button to confirm. In the same screen is showed the reflected power and the SWR
Audio source
This menu allows to set several parameters of audio input
Parameters
Input
Max audio level
(only for analog input)
Audio gain left
Audio gain right
AF level meter
Mono config
(only for mono Mode)
10
In order to activate the RF output press the 3
at the bottom (see indication "ON" on the display).
During this interval (10 sec.) it is possible to switch off
the RF output. If no button is pushed, at the end of the
timer the RF output is enabled automatically.
Range setting Function
digital/analog To set the audio input
-6/0/6/12/18 dBu To change (increase or decrease) the analogue audio
input for both R(right) and L(left) channels input
-20÷24dB To change (increase or decrease) the input level of the
left channel on DSP
-20÷24dB To change (increase or decrease) the input level of the
right channel on DSP
input/modulation To set which AF level is shown in the two LED bars for the
AF levels (L=left & R=right levels): they can show AF input
levels or modulation levels (after the pre-emphasys and
compander phases)
Mono/mono- To set the type of mono input
R/mono-L
(Stationary Wave Ratio) sensing on antenna outputs.
The set TX power and the measured SWR are always
showed at the bottom of the display.
rd
button