340i Integrated Amplifier
Remote Control Operation
Figure 7: CRM-2 Remote Control
____________________________________________________________________________________
(cont'd)
The Nēo 340i Integrated Amplifier uses the 'CRM-2' full-function remote control
(figure 7). It operates on the Philips RC-5 communication protocol and is can be
used with other Simaudio MOON components.
The 'CRM-2' remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the 'CRM-2' remote for use with the Nēo 340i Integrated Amplifier,
you must first press the button labeled AMP.
The POWER button located on the upper left will switch the integrated amplifier to
either 'Standby' or 'On' mode.
The DISPLAY button turns the front panel display on and off
The 2 buttons labelled
backwards or forwards, through all six (6) available inputs. For example, to switch
from the "CD" to the "VIDEO" input you may press either
►
times or INPUT
three (3) times. Pressing and holding down either of
these buttons results in only a single change to the selected input.
The 2 buttons labelled
▼
VOL results in a decrease in the volume level; Pressing VOL
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the "Mute" button a
second time will reinstate the output volume level back to its current setting.
NOTE: The 2 buttons labelled ◄ BAL ► don't affect the operation of the 340i.
◄
INPUT
►
allow you to sequentially scroll, either
▼
VOL
▲
allow you to control the volume level. Pressing
◄
INPUT three (3)
▲
results in an
14