moon Neo 340i Owner's Manual page 16

340i Integrated Amplifier
Specifications
Optional
Digital-to-Analog Converter:
Digital Input Types .................................................. S/PDIF (RCA) x 2
Digital Input Impedance (S/PDIF) ........................... 75 ohms @ 0.5 Volts
DAC / Digital Filter ................................................... BurrBrown PCM1793
Bit-depth range ...................................................... 16 - 24 bits
Sampling Frequency Rates ....................................... 44.1, 48, 88.2, 96, 176.4 and 192kHz
Frequency Response (audible) ................................ 20Hz - 20kHz +0/-0.2dB
Frequency Response (full range) ............................ 2Hz - 72kHz +0/-3dB
THD @ 1kHz, 0dBFS (A-weighted) ......................... < 0.001 %
IMD ....................................................................... < 0.004 %
Dynamic Range ...................................................... > 116dB
Signal-to-noise ratio ............................................... > 115dB @ full output
Slew Rate .............................................................. 50V/µs
Channel Separation ................................................ > 115dB
Low Level Linearity ................................................. ±1.0dB to below 120dBFS
Intrinsic Jitter ......................................................... < 25 picoseconds
Balanced Pin Assignment: Pin 1................................ Ground
12 Volt Trigger:
NOTE: If you require the RS-232 codes for your Nēo 340i, please contact Simaudio Ltd.
directly by either email (service@simaudio.com) or by toll-free telephone (877-980-2400).
Fuse Replacement:
____________________________________________________________________________________
(cont'd)
Pin 2................................ Positive
Pin 3 .............................. Negative
Logic ............................... Direct (0V off, 12V on)
Jack................................. 3.5mm microphone jack
Input Impedance.............. 1kΩ
Current Consumption........ 12mA
For the 120V version use a 5A fast blow (3AG size).
For the 220 - 240V version use a 3A fast blow (3AG size).
USB x 1 TosLink x 1
RMS
16