LifeSpan C3i Owner's Manual page 16

Step 8: Console Assembly
A. Align the console (9) with the console
mounting bracket (K). Connect the
two 2-pin connectors (J) coming from
the console to the two 2-pin
connectors (I) coming from the
handlebar assembly (8). Push any
excess wire into the opening in the
back of the console (9).
Note: It does not matter which
connectors plug into each other as
long as both connectors are
plugged in.
B. Connect the green ground connector
coming from the handlebar assembly
to the green wire coming from the
console.
C. Connect the remaining large
connector directly into the
corresponding white connector on
the console circuit board (S).
D. Place the console (9) onto the console
mounting bracket (K).
E. Install four M4 screws (21) through the
console mounting bracket (K) and into
the console (9). Once all four screws
are installed securely tighten them.
16
J
I
K
21
9
S
8