Configuring Port Settings - HIKVISION Network Camera User Manual

User Manual of Network Camera
2. Configure the NIC settings, including the NIC Type, IPv4 Address, IPv4 Subnet
Mask, IPv4 Default Gateway, MTU settings and Multicast Address.
Notes:
 The valid value range of MTU is 500 ~ 9676.
 The Multicast sends a stream to the multicast group address and allows
multiples clients to acquire the stream at the same time by requesting a copy
from the multicast group address. Before utilizing this function, you have to
enable the Multicast function of your router.
3. If the DHCP server is available, you can check
IP address and other network settings from that server.
4. If the DNS server settings are required for some applications (e.g., sending email),
you should properly configure the Preferred DNS Server.
5. Click

5.3.2 Configuring Port Settings

Purpose:
You can set the port No. of the camera, e.g. HTTP port, RTSP port and HTTPS port.
Steps:
1. Enter the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
TCP/IP Settings
Figure 5-7
DNS Server Settings
Figure 5-8
to save the above settings
to automatically obtain an
.
21