Adding And Removing Sensors - Linear SSD8 Installation Instructions & Owner's Manual

ADDING AND REMOVING SENSORS

SELECT
OFF MODE
YOUR SECRET CODE, THEN [#]
CHECK STATUS
INDICATORS
FOR VACANCIES
(LIGHTS THAT
ARE OFF)
SELECT A VACANT
SENSOR # (1-8)
3
def
STATUS
LIGHT
BLINKS
SELECT A
SENSOR # (1-8)
3
def
STATUS
LIGHT
BLINKS
PRESS & HOLD [OFF]
WHEN
FINISHED
ACTIVATE REMOTE BY
PRESSING LEFT BUTTON
10
STATUS
LIGHT
ACTIVATE
SOLID
SENSOR
STATUS
LIGHT
OUT
PRESS
CHIME
Chime
FOR 2 SECONDS
Off
ACTIVATE DOOR/WINDOW
SENSOR BY PRESSING CASE
Additional sensors of various types can be
purchased for the Console.
Up to eight sensors can be used with each Console.
Each accessory is supplied with
installation and programming
instructions. The programming
information supplied pertains to the
16-sensor SSD system. Use the
following programming information
when using the accessories with the
8-sensor SSD8 system.
The two sensors supplied with the unit are
pre-programmed into sensor locations #1 and #2.
To add or remove sensors:
1. Start with the system in the Off Mode.
2. Enter your secret code and press [#]. A gong
followed by four beeps should sound. All occupied
sensor locations will have sensor status indicators lit.
3A. TO ADD SENSORS: Press the number (1-8) of
a vacant sensor location. The sensor status indicator
for that sensor number will start flashing. Activate the
sensor (details in the accessory instructions). A
"bing" should sound and the sensor status indicator
should light steady, showing that the location is now
occupied. NOTE: A double-buzz sound means that
the location is occupied, choose a vacant location.
3B. TO REMOVE SENSORS: Press the number
(1-8) of the sensor to remove. The sensor status
indicator for that sensor number will start flashing.
Press [CHIME], a "bing" should sound, and the
indicator should go out, showing that the location is
now vacant.
4. Repeat Step 3A or 3B for additional sensors.
When finished, press and hold [OFF] for 2 seconds,
a "gong" will sound and the system will return to the
Off Mode.
ACTIVATE MOTION DETECTOR
BY PRESSING THE WALK
TEST BUTTON