Caution - Exerpeutic 97670 Owner's Manual

CAUTION

Before beginning a workout session ensure that the Safety Tether Key is properly inserted into the Computer Console and the
Safety Clip is securely attached to an article of your clothing. Always begin the treadmill standing on the side rails, not on
the running belt. Allow the treadmill to reach a speed of at least 0.4 m/h. before walking on the running belt.
Operating in Quick Start Mode
Ensure this treadmill is plugged into a nominal 120-volt 60 hz, which has a grounding plug.
Step 1:
Power Up
Press the Master Power Switch located at the front of the treadmill to the ON position. The LCD console will
immediately run a self diagnostic display. After that it will display current system status.
Step 2:
Begin Workout
Press the START button then "Speed" to begin operation.
As the running belt speed reaches 0.4 m/h, you can start walking on the treadmill. Adjust to desired speed using the
UP button. Press the DOWN button to decrease the speed. The LCD console will immediately display when you
adjust the speed.
9