Cancelling The Alarm While Sounding; Min / Max Mode; Max Mode - Ambient Weather WS-5300 User Manual

6. Indoor Humidity Low Alarm. Press the
will begin flashing. Press the + button or
alarm setting.
To set the indoor humidity alarm, press the
flashing, and the alarm icon
button again, and the alarm icon will turn off.
When the indoor humidity exceeds the alarm setting, the alarm will sound.
7. Indoor Temperature Low Alarm. Press the
alarm will begin flashing. Press the + button or
temperature alarm setting.
To set the indoor temperature alarm, press the
is flashing, and the alarm icon
ALARM button again, and the alarm icon will turn off.
When the outdoor temperature exceeds the alarm setting, the alarm will sound.
Press the SET button again to exit the high alarm setting mode.

5.3.2 Cancelling the Alarm While Sounding

To cancel an alarm that is sounding, press any key and the alarm will be silenced. Otherwise, the
alarm will time out in 120 seconds.
When a weather alarm is triggered (all alarms except for the time alarm), the alarm will also turn off if
the alarm set point is no longer exceeded.
After an alarm is activated, the icon will flash for three hours but the alarm will not continue to sound
to avoid repeated triggering of the same alarm value (nuisance alarms).
After three hours, if the alarm set point is exceeded, the alarm will sound again.

5.4 Min / Max Mode

To enter the Min/Max mode from the normal mode, press (do not hold) the
backlight turns on and the console beeps. The maximum values and the MAX icon will be displayed.
To view the minimum values, press the
To exit the min/max mode, press the
The following section outlines resetting min/max values. The process is identical for minimum and
maximum settings (depending on which mode is displayed).
The min/max modes can be exited at any time by either pressing the
the 30-second time-out to take effect. You can skip over any setting by pressing the
again.

5.4.1 Max Mode

After entering the maximum display mode (reference Section 5.4), press the + button to display the
maximum values and associated time and date stamp it occurred as referenced in Table 1. While the
Version 1.3
will turn on. To turn off the alarm, press the
LO AL
LO AL
MIN/MAX
button again.
MIN/MAX
©Copyright 2013, Ambient LLC. All Rights Reserved.
button again and the indoor humidity alarm
SET
button to change the indoor humidity
MIN/MAX
button while the indoor humidity is
ALARM
SET button again and the indoor temperature
MIN/MAX button to change the indoor
button while the indoor temperature
ALARM
will turn on. To turn off the alarm, press the
button again and the MIN icon will be displayed.
HISTORY
ALARM
button. The
MIN/MAX
button or waiting for
button
SET
Page 19