Ambient Weather WS-5300 User Manual page 31

Problem
Indoor and Outdoor Temperature do not
agree
Indoor and Outdoor Humidity do not
agree
Rain gauge reports rain when it is not
raining
Wind speed appears low
Display console is difficult to read
Can the lamp be turned on all of time?
Version 1.3
Solution
2. Install a fresh set of batteries in the remote
3. The maximum line of sight communication
4. If the sensor assembly is too close (less than
5. Make sure the remote sensors are not
6. Move the display console around electrical noise
7. Move the remote sensor array to a higher
Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature
sensors should agree within 4 °F (the sensor accuracy is
± 2 °F)
Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor humidity sensors
should agree within 10 % (the sensor accuracy is ± 5 %)
An unstable mounting solution (sway in the mounting
pole) may result in the tipping bucket incorrectly
incrementing rainfall. Make sure you have a stable
mounting solution. Move the rain gauge from the pole
mount to a flat, stable mount (fixed, flat structure).
Average wind speed may have the appearance of low
wind. Try switching the display to wind gust.
Change the display contrast level.
Replace the batteries in the console with a fresh set of
batteries.
No, to prevent the bulb from burning out, it can only turn
on temporarily.
©Copyright 2013, Ambient LLC. All Rights Reserved.
while in the search mode.
sensor array. For cold weather environments,
install lithium batteries.
range is 300', 100' under most conditions. Move
the sensor assembly closer to the display
console.
5-10'), move the sensor assembly away from the
display console.
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
location. Move the remote sensor array to a
closer location.
Page 31