Table of Contents
Advertisement
level and not the calibrated temperature level. Only the console will show the calibrated value.
Note: The dew point calculation is based on the calibrated temperature level.
4.3 Alarm Mode
4.3.1 Alarm Display
While in Normal Mode, press the ALARM key to enter the High Alarm Mode. Press the ALARM
key again to enter the Low Alarm Mode. Press the ALARM key again to return to normal mode (or
wait 30 seconds).
Note: After entering the ALARM mode, the console will display the high and low alarm
settings. If the value reads --.-- (dashes), the alarm is not active.
4.3.2 Alarm Programming
While in Alarm Mode, press the SET key to set the alarms. The following are high and low alarms:
High Alarm Limits:
Time alarm (hour/minute)
Indoor humidity high alarm
Indoor temperature high alarm
Outdoor humidity high alarm
Outdoor temperature / dew point high alarm
Pressure high alarm
Low Alarm Limits:
In the Low Alarm Mode press the SET key to select the following alarm modes:
Time alarm (hour/minute)
Indoor humidity low alarm
Indoor temperature low alarm
Outdoor humidity low alarm
Outdoor temperature / dew point low alarm
Pressure low alarm
In the alarm mode, Press the
specific alarm is flashing.
Hold the
+
key or MIN/MAX key for 3 seconds to change the number rapidly. Press the ALARM key
to select the alarm on or off (if alarm is enabled, the speaker icon on the LCD will be turned on
indicating the alarm function has been enabled).
Press the SET key to confirm the setting and continue pressing the SET key to toggle through each
alarm mode until it returns to the normal display mode.
Press the SNOOZE key or wait 30 seconds, and the alarm mode will return to the normal mode.
4.3.3 Cancelling the Alarm
When an alarm condition has been activated, the specific alarm will sound and flash for 120 seconds.
Version 1.2
©Copyright 2013, Ambient LLC. All Rights Reserved.
key or MIN/MAX key to change or scroll the alarm value while the
+
Page 12
Advertisement
Table of Contents
