Organ - Roland JP-8080 Owner's Manual

Organ

2
1
Use the Initialize operation to set the Performance
to the basic settings.
[INIT/UTIL]: Initialze: PERF: TEMPORARY
2
In the OSC1 section [WAVEFORM], select SUPER
SAW.
3
Move the OSC1 section [CONTROL 1] (DETUNE)
to the position shown in the diagram.
4
Move the OSC1 section [CONTROL 2] (MIX) to the
maximum position.
5
The Edit Scope page will appear.
[SCOPE]: Edit Scope
By moving the sliders/knobs, you can set the various
parameters while you watch the values. If you wish to
make precise changes, you can use [DEC]/[INC] to
change the value in steps of one.
6
In the FILTER section, set the [KEY FOLLOW]
value to +32.
7
In the FILTER section, set the [RESONANCE] value
in the range of 65–75.
EXT
-2
3, 10 4
8
7 6
9
8
In the FILTER section, set the [CUTOFF FREQ]
value to 71.
This will use filter oscillation to add a parallel fifth har-
mony.
Changing the cutoff frequency value in steps of 1 will
change the pitch of the oscillation in semitone steps. If
you wish, you can select a different pitch as desired.
Examples) 64 1 octave
68 third
75 seventh
9
Move the FILTER ENVELOPE section [DEPTH] to
the position shown in the diagram.
This will adjust the click sound which occurs when a
key is released.
10
As desired, you can move the OSC1 section [CON-
TROL 1] (DETUNE) to adjust the rotational speed
of the rotary speaker.
161