Making Overall Settins (Setup); Setting The Lcd Contrast - Roland JP-8080 Owner's Manual

* If you want the JP-8080 to receive the MIDI message that
it transmitted, the Edit Transmit/Receive Mode must be
the same during both transmission and reception. If dif-
ferent settings are used, the MIDI messages cannot be
received.
Tx/Rx Setting
(Transmit/Receive Setting)
The MIDI message assigned to each slider/knob when the
Edit Transmit/Receive Mode is MODE2.
While this setting page is displayed, moving a slider or
knob will cause the MIDI message assigned to that con-
troller to appear in the display. Now you can use
[DEC]/[INC] to specify the desired MIDI message.
The following MIDI messages can be assigned to each con-
troller.
OFF: No MIDI message will be assigned. Moving the con-
troller will not cause MIDI message to be transmitted.
MODULATION: CC01–CC31, CC33–PHASER: CC95,
AFTERTOUCH, EXCLUSIVE:
The corresponding MIDI message will be assigned.
* CC indicate the controller number (p.169).
* While the setting screen is displayed, moving
sliders/knobs will not edit the various parameters. Also,
the MIDI messages assigned to the various controllers
will not be transmitted.
* If you want the JP-8080 to receive the MIDI message of
the slider/knob that it transmitted, the Transmit/
Receive Setting must be the same during both transmis-
sion and reception. If different settings are used, the
MIDI messages cannot be received.
Tx/Rx ProgChg SW
(Program Change Transmit/Receive Switch)
If you want to select sounds on an external MIDI device
remotely from the JP-8080, or to select JP-8080 patches or
performances from an external MIDI device connected to
the JP-8080's MIDI IN connector, you must make settings to
specify whether program change and bank select messages
will be received and transmitted.
OFF: Program Change and Bank Select messages will be
neither transmitted nor received.
PC: Only Program Change messages will be transmitted
and received.
BANK SEL + PC: Program Change and Bank Select mes-
sages will be transmitted and received.
* These messages will be received at the REMOTE KBD
IN connector if the Remote KBD CH is ALL, or if the
MIDI channel of the program change or bank select
matches the MIDI channel setting.
Control Up/Control Down
Some MIDI messages are able to modify multiple parame-
ters simultaneously. You can select which MIDI messages
will modify parameters. For details refer to "Control Using
MIDI Messages Other than Aftertouch and Breath (Control
Up/Down)" (p.86).
Making Overall Setting
(Setup)
These settings are common to the entire JP-8080.
1
Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
2
Press [SETUP] (BANK [6]) several times to select
the parameter whose settings you wish to modify.
* If you hold down [SHIFT] and press [SETUP], you will
return to the previous display page.
The [SETUP] indicator will light.
3
Use [DEC]/[INC] to set the value.
4
When you finish making settings, press [EDIT] or
[EXIT].
The previous display will reappear.
The following five parameters can be set.
* For details on parameters, refer to the page given.
LCD Contrast
Master Tune
Power Up Mode
Pattern Trig Qtz (Pattern Trigger Quantize)
"Setting the Timing at Which Patterns Will Switch
(Pattern Trigger Quantize)" (p.93)
Motion Restart (Motion Restart)
"Playing Back a Motion From the Beginning Each
Time a Key is Pressed (Motion Restart)" (p.99)

Setting the LCD Contrast

LCD Contrast
This adjust the brightness of the display. Adjust it for best
visibility.
1–8
125