Roland JP-8080 Owner's Manual page 197

Poly (Controller number 127)
status 2nd byte 3rd byte
BnH 7FH 00H
* This is received only when Remote KBD CH ([MIDI]) is ALL or when the MIDI chan-
nel of the poly message matches.
* The same processing will be performed as when All Note Off is received, and [MONO]
will be turned off for the patch of the part specified by PANEL SELECT.
System Realtime messages
Active Sensing
status
FEH
* When an Active Sensing message is received, the unit will begin monitoring the inter-
vals of all further messages. During monitoring, if more than 400 ms passes without a
message being received, the same processing will be done as when All Note Off and
Reset All Controllers messages are received. Then monitoring will be halted.
Timing Clock
status
F8H
* This is received when MIDI Sync ([MIDI]) is set to REMOTE KBD IN.
Start
status
FAH
* This is received when MIDI Sync ([MIDI]) is set to REMOTE KBD IN.
Continue
status
FBH
* This is received when MIDI Sync ([MIDI]) is set to REMOTE KBD IN.
Stop
status
FCH
* This is received when MIDI Sync ([MIDI]) is set to REMOTE KBD IN.
System Exclusive messages
* Regardless of the Exclusive Receive Switch setting, REMOTE KBD IN will always
receive exclusive messages for the parameters of the patch/performance in the tempo-
rary area. However, patch parameters and performance part parameters will be
received by the part that is selected by Panel Select. No other exclusive messages will
be received.
status data byte status
F0H iiH, ddH, ......, eeH F7H
F0H: System Exclusive message status
ii = ID number: This is the ID number (manufacturer ID) that specifies the manufacturer
whose exclusive message this is. Roland's manufacturer ID is 41H. ID
numbers 7EH and 7FH are defined in an expansion of the MIDI stan-
dard as Universal Non-realtime messages (7EH) and Universal
Realtime Messages (7FH).
dd,..., ee = data: 00H - 7FH (0 - 127)
F7H: EOX (End Of Exclusive)
Data Set 1 DT1
This message transmits the actual data, and is used when you wish to set the data of the
receiving device.
status data byte
F0H 41H, dev, 00H, 06H, 12H, aaH, bbH,
ccH, ddH, eeH, ... ffH, sum
Byte Remarks
F0H Exclusive status
41H ID number (Roland)
dev device ID (dev: 10H - 1FH, factory setting is 10H)
00H model ID (JP-8080)
06H model ID (JP-8080)
12H command ID (DT1)
aaH address MSB
bbH address
ccH address
ddH address LSB
eeH data: The actual data to be transmitted. Multi-byte data is transmitted in the
order of the address.
: :
ffH data
sum checksum
F7H EOX (End Of Exclusive)
* Only data set 1 for patch parameters and performance parameters is received. For
patch parameters, this message will affect the patch parameters of the part selected by
PANEL SELECT at that time, regardless of the parameter address which was received.
* For details on address, size, and checksum settings, refer to "Examples of exclusive
messages and calculating the checksum" (p.206).
* Data whose size is greater than 256 bytes should be divided into packets of 256 bytes
or less and transmitted. Successive "Data Set 1 messages should have at least 20 ms of
time interval between them.
status
F7H
197