Bass (2) - Roland JP-8080 Owner's Manual

Bass (2)

11 10 12
9
1
Use the Initialize operation to set the performance
to the standard settings.
[INIT/UTIL]: Initialze: FPERF: TEMPORARY
2
Since the bass has a low pitch range, set the OSC
COMMON section OSC SHIFT to "-2OCT."
3
In the OSC COMMON section, move OSC BAL-
ANCE to the position shown in the diagram.
OSC1 and OSC2 will have the same volume.
4
In the OSC2 section, move [RANGE] to the position
shown in the diagram.
OSC2 will sound one octave lower.
5
In the FILTER section, move [CUTOFF FREQ] to
the position shown in the diagram.
The sound will become more muted.
6
In the FILTER ENVELOPE section, move [DEPTH]
[D] [R] to the position shown in the diagram.
7
In the AMP section, set [LEVEL] to the maximum.
8
In the AMP ENVELOPE section, move [A] and [R]
to the position shown in the diagram.
9
Make SOLO SW [LEGATO] light to turn it on.
When you play legato, the pitch will change without a
new attack, similarly to the result of sliding a finger on a
string without releasing the fretboard.
EXT
-2
3 2 4 5 6, 13
10
Make PORTAMENTO [ON] light to turn in on.
11
Move PORTAMENTO [TIME] to the position
shown in the diagram.
12
Increase TONE CONTROL [BASS] as desired to
boost the low range.
* Be careful, since increasing this excessively may damage
your speakers etc.
13
Increasing the FILTER ENVELOPE section
[DEPTH] will produce a "plucked" character.
7
6 8
153