Roland JP-8080 Owner's Manual page 148

Initialize to one of the following: F.FLT: VINTAGE /
F.FLT: SILKY/F.FLT: HUSKYVOICE/F.FLT: BREAK-
BEATS.
VOICE MODULATOR [ON] will be turned on.
[VOICE MOD SEND] for the Lower part will also be on,
and the external sound synthesized by the Lower part
will be input to the Voice Modulator.
9
Turn Ext->Inst Send off.
[VOICE MOD]: Ext->Inst Send (p.109)
The external sound will no longer be input directly to
the Voice Modulator, and only the external sound syn-
thesized by the Lower part will be input.
10
Use the EXTERNAL INPUT [VOCAL/UPPER] to
adjust the volume of the mic input.
To obtain a formant filter effect, simultaneously input an
external sound (by playing a note or playing back a tape
or CD) and input your voice from the mic.
11
Hold down [SHIFT] and press PANEL SELECT
[UPPER].
The Voice Modulator panel will be selected. Move the
sliders/knobs to modify the values of various Voice
Modulator parameters.
* If you wish to input audio from a tape or CD instead of
from a mic, input the sound from the VOCAL/UPPER
jack. In this case, turn [REAR/FRONT] off (REAR).
If you input a tape or CD from the INST/LOWER jack
The effect will be obtained only while you are playing a
note. If you wish to obtain the effect simply by inputting the
sound without having to play a note, make the following
settings.
1
Press PANEL SELECT [LOWER] to select the Lower
part.
* If the Voice Modulator panel is selected, press [EXIT]
and then press [LOWER].
2
Turn on the Ext Trig Switch.
[PATCH]: Ext Trig Switch (p.121)
3
Set Ext Trig Dest to either AMP or FILTER&AMP.
[PATCH]: Ext Trig Dest (p.121)
4
Set OSC 2 [CONTROL 1] to the minimum position.
148
(2) Filter Bank
Here's how you can synthesize an external sound using
both the Upper and Lower parts, and input that sound into
the Voice Modulator.
JP-8080
INST/LOWER VOCAL/UPPER
OUTPUT
Synthesizer (keyboard)
JP-8080
INST/LOWER VOCAL/UPPER
OUTPUT
Tape/CD player
1
As shown in the diagram, connect your external
device to the JP-8080.
2
Initialize the performance to a standard set of set-
tings.
[INIT/UTIL]: Initialize: PERF: TEMPORARY (p.140)
3
Set [KEY MODE] to DUAL.
Upper and Lower will sound simultaneously.
4
Make sure that PANEL SELECT is set to UPPER.
5
Set AMP [PAN] to MANUAL, and set AMP [LFO 1
DEPTH] to the R position.
The Upper sound will be assigned to the right.
6
Press PANEL SELECT [LOWER] to select the Lower
part.
7
Set AMP [PAN] to MANUAL, and set AMP [LFO 1
DEPTH] to the L position.
The Lower sound will be assigned to the left.
8
Simultaneously press PANEL SELECT [UPPER]
and [LOWER].
Now you can edit the sound of both parts simultaneously.
REMOTE KBD IN
MIDI OUT
REMOTE KBD IN
MIDI OUT
MIDI keyboard