Roland JP-8080 Owner's Manual page 139

Notes when bulk dumping sound data from the Roland JP-8000 sequencer to
the JP-8080
The JP-8080 has parameters which do not exist on the JP-8000 (Unison, Voice Modulator etc.). When JP-8000 data is
bulk dumped to the JP-8080, parameters unique to the JP-8080 will not be overwritten, but will remain with their pre-
vious settings.
Thus, if you wish to bulk dump JP-8000 sounds to the JP-8080 and reproduce the identical settings, please use the fol-
lowing procedure.
The procedure will depend on the type of bulk dump.
* If you are bulk dumping JP-8000 motion settings to the JP-8080, no special operations are required before bulk
dumping.
* The JP-8080 cannot receive JP-8000 pattern settings as a bulk dump.
Bulk dumping a performance/patch from the JP-8000's temporary area to the JP-8080
Refer to the table below, and initialize the performance/patch in the JP-8080's temporary area (p.140). Then execute
the bulk dump.
Bulk dump performed on the JP-8000
PERFORM: TEMP
PATCH: TEMP UPPER
PATCH: TEMP LOWER
PATCH: TEMP UP&LO
Bulk dumping JP-8000 user area data to the JP-8080
Refer to the following table, and restore the data in the JP-8080's user area to the factory settings (Factory Reset: p.140).
Then execute the bulk dump.
Bulk dump transmitted from the JP-8000
ALL
PERFORM: USER ALL
PATCH: USER ALL
PATCH: USER A
PATCH: USER B
* Even if you select ALL on the JP-8000 and execute bulk dump, the JP-8080 will not receive RPS pattern settings.
Data initialized on the JP-8080
PERF: TEMPORARY
PATCH: TEMPORARY (upper only)
PATCH: TEMPORARY (lower only)
PATCH: TEMPORARY (both upper and lower)
Restorning the factory reset on the JP-8080
JP-8000 ALL
JP-8000 PERF
JP8000 PATCH
JP8000 PAT.A
JP8000 PAT.B
139