Aleratec 1:11 HDD Copy Cruiser IDE/SATA User Manual page 45

Using the 1:11 HDD Copy Cruiser IDE/SATA
Main Menu
Adv Setup
Adv Setup: Update Firmware
This function is used to update the 1:11 HDD Copy Cruiser IDE/SATA firmware to
a later version.
Note: Firmware updates are available from Aleratec technical support.
1.a CD method
Open the case of the 1:11 HDD Copy Cruiser IDE/SATA . Disconnect the SATA
cable from the blue connector on the controller board. Connect a SATA DVD/CD
drive (not included) to the blue connector. Place the firmware CD in the DVD/CD
drive.
1.b Hard Drive method
Format a hard drive and create a single partition to the smallest capacity
allowable. Copy the firmware file into the root directory of this partition.
2. Power on the 1:11 HDD Copy Cruiser IDE/SATA. Once the system has
completed its startup process, press and hold the ESC button for about 3
seconds to access "Adv Setup". The following screen will be displayed.
11. Adv Setup
3. Use the arrow buttons () to select "Update Firmware", and then press
ENT. The system will begin scanning for a new firmware version. If found,
screens similar to the following will be displayed.
Searching F/W...
Please Wait...
Press ENT to begin the firmware update. If the upgrade is successful, the
4.
system will restart automatically.
ENT

www.aleratec.com

ESC

Update F/W
To *.** Yes
1.04N
39