Async Copy Hdd - Aleratec 1:11 HDD Copy Cruiser IDE/SATA User Manual

Using the 1:11 HDD Copy Cruiser IDE/SATA
Main Menu
Async Copy
The function "Async Copy" allows you to insert target drives during the copying
operation. During the process, you can insert another drive as a target of the Async
Copy operation and the unit will automatically copy to this new drive as well.
1. Load the source HDD and the target HDDs into the 1:11 HDD Copy Cruiser
IDE/SATA. The system will auto-detect the hard drives. After the drives have
been detected, a screen similar to the one below will be displayed.
2. Async Copy
Note: Before copying be sure that the capacity of the target HDD is
equal to or larger than the source hard drive.
Press ENT to start copying. The system will auto-detect the hard drives. The
2.
following information will be displayed.
Detect Drives
Please wait...
3. During the copy process the 1:11 HDD Copy Cruiser IDE/SATA will display
progress information.
Copy- 36MB/s
235.7GB
The amount of data remaining to be transferred (shown in gigabytes), and time
will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one
source hard drive to another.

ENT


ENT


0%
ENT
1:48

www.aleratec.com
ESC
ESC
ESC
15