Secure Computing SG300 User Manual page 84

Warning
We strongly recommend that the wireless interface be configured as a LAN connection
only if wireless clients are using WPA based encryption/authentication. This is
discussed in further detail later in this section.
Configuring a Direct Connection is described in detail in the section entitled Direct
Connection towards the beginning of this chapter. See the sections DMZ Network and
Guest Network earlier in this chapter for further discussion of these network types.
In addition to connection configuration, you may also configure wireless access point,
access control list (ACL) and advanced settings. These settings are described in the
following section.
Note
A walkthrough for configuring your SnapGear unit to bridge wireless clients directly onto
your LAN is provided in the section entitled Connecting wireless clients, towards the end
of the Wireless section.
Basic wireless settings
To edit basic wireless settings, click the Edit icon alongside the Wireless network
interface, click the Wireless Configuration tab, then the Access Point tab. Each of the
fields is discussed below.
78
Network Setup