Ipsec Troubleshooting - Secure Computing SG300 User Manual

parent
start route add -net 192.168.1.0 netmask 255.255.255.0 dev
gre2
stop route del -net 192.168.1.0 netmask 255.255.255.0 dev
gre2
maximum_retries 2147483647
retry_delay
test_delay 5
connection primary_ping
parent
maximum_retries 2147483647
retry_delay
test_delay 5
test ifretry 2 5 ping -I 210.0.0.1 209.0.0.1 -c 3
connection secondary_ping
parent
maximum_retries 2147483647
retry_delay
test_delay 5
test ifretry 2 5 ping -I 210.0.1.1 209.0.1.1 -c 3
service service-IPSec
group primary_ping
group secondary_ping

IPSec Troubleshooting

Symptom: IPSec is not running and is enabled.
Possible Cause: The SnapGear unit has not been assigned a default gateway.
Solution: Ensure the SnapGear unit has a default gateway by configuring the
Internet connection on the Connect to Internet page or assigning a default gateway
on the IP Configuration page.
Virtual Private Networking
secondary_ping
5
conn-gre1
5
conn-gre2
5
247