Dial-In - Secure Computing SG300 User Manual

Port settings
If necessary, you may set the SnapGear unit's serial port Baud rate and Flow Control.
This is not generally necessary.
Static addresses
The majority of ISPs dynamically assign an IP address to your connection when you dial-
in. However some ISPs use pre-assigned static addresses. If your ISP has given you a
static IP address, click the Static Addresses tab and enter it in My Static IP Address
and enter the address of the ISP gateway in ISP Gateway IP Address.
Aliases
See the section entitled Aliases under Direct Connection.
Connection (dial on demand)
See the section entitled Connection (dial on demand) under ADSL.

Dial-in

A remote user may dial directly to a modem connected to SnapGear unit's serial port.
Once connected and authenticated, the user has access to network resources as if they
were a local user on the LAN. This may be useful for remote administration of your
SnapGear unit, or for telecommuting.
Dial-in setup
From the Change Type pull-down menu, select Dial-in (for the interface that connects to
the dialup modem to answer incoming calls.
Network Setup
56