Secure Computing SG300 User Manual page 42

Select Use the following IP address and enter the following details:
IP address:
Subnet mask:
Leave the Default gateway and DNS server addresses blank.
Set up the SnapGear unit's password and network connection settings
Launch your web browser and navigate to 192.168.0.1.
Select Network Setup from the Networking menu.
A login prompt is displayed. Enter the initial user name and password for the SnapGear
unit:
User name:
Password:
Note
If you are unable to connect to the management console at 192.168.0.1, or the initial user
name and password are not accepted, press the Reset button on the SnapGear unit's
rear panel twice, wait 20 – 30 seconds, and try again.
Pressing Reset twice within 2 seconds resets the SnapGear unit to its factory default
settings
Enter and confirm a password for your SnapGear unit. This is the password for the user
root, the main administrative user account on the SnapGear unit. It is therefore
important that you choose a password that is hard to guess, and keep it safe.
Getting Started
192.168.0.100
255.255.255.0
root
default
36