Secure Computing SG300 User Manual page 31

Next, modify your PC's network settings to enable it to communicate with the SnapGear
unit.
Click Start > (Settings >) Control Panel and double-click Network Connections (or in
95/98/Me, double-click Network).
Right-click Local Area Connection then select Properties.
Note
If there is more than one existing network connection, select the one corresponding to the
network interface card to which the SnapGear unit is attached.
Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP > your
network card name if there are multiple entries) and click Properties.
Select Use the following IP address and enter the following details:
IP address:
Subnet mask:
Default gateway:
Select Use the following DNS server addresses and enter:
Preferred DNS server:
Getting Started
192.168.0.100
255.255.255.0
192.168.0.1
192.168.0.1
25