Figure 3.33: 802.1Q Vlan Configuration - Advantech EKI-7758F User Manual

802.1Q Configuration
• Pull down the select item menu of VLAN Operation Mode, and select Port Based mode.
• Enable GVRP Protocol: mark the check box to enable GVRP protocol that allows network devices to
dynamically exchange VLAN configuration information with other devices. If GVRP protocol is not
enabled, user has to set the tagging information manually.
• Select the port that you want to configure.
• Link Type: there are 3 types of link type.
Access Link: single switch only, allow user to group ports by setting the same VID.
Trunk Link: extended application of Access Link, allows user to group ports by setting the
same VID with 2 or more switches.
Hybrid Link: Both Access Link and Trunk Link are available.
• Untagged VID: assign the untagged frame VID.
• Tagged VID: assign the tagged frame VID.
• Click Apply
Group Configuration
Edit the existing VLAN Group.
• Select the VLAN group in the table list.
• Click Apply

Figure 3.33: 802.1Q VLAN Configuration

63 Chapter3