Figure 3.4: Command Line Interface; Commands Level; Table 3.1: Command Level - Advantech EKI-7758F User Manual

After you have logged in to the system, you will see a command prompt. To enter CLI management interface,
type in "enable" command.
The following table lists the CLI commands and description.
3.1.1

Commands Level

Table 3.1: Command Level

Modes Access Method
Begin a session with
your switch.
User EXEC
Enter the enable
command while in
Privileged user EXEC mode.
EXEC
Enter the configure
Global command while in
configuration privileged EXEC
mode.
Enter the vlan
database command
VLAN database
while in privileged
EXEC mode.
Enter the interface
command (with a
specific interface)
Interface
while in global
configuration
configuration mode
EKI-7758F User Manual

Figure 3.4: Command Line Interface

Prompt Exit Method
Enter logout or quit.
switch>
Enter disable to exit.
switch#
To exit to privileged
EXEC mode, enter
switch(config)#
exit or end
To exit to user EXEC
mode, enter
switch(vlan)#
exit.
To exit to global
configuration mode,
enter exit.
switch(config-if)#
To exist to privileged
EXEC mode, or end.
26
About This Model
The user commands available
at
the user level are a subset of
those available at the
privileged level.
Use this mode to
• Perform basic tests.
• Display system information.
The privileged command is
advance mode
Privileged this mode to
• Display advance function
status
• save configures
Use this mode to configure
parameters that apply to your
switch as a whole.
Use this mode to configure
VLAN-specific parameters.
Use this mode to configure
parameters for the switch and
Ethernet ports.