Configuring Windows To Print On A Netware Network - Tally T8006 User Manual

5. In the Printer Ports window, select LPR Port and then select New
Port.
6. In the Add LPR Compatible Printer window, enter the IP address,
enter LPT1 for the printer name, and click OK.
7. In the Printer Properties window, click Close to complete the port
installation.
Configuring the TCP/IP Printer Port in Windows 2000
By default, your printer is installed on LPT1 — the physical printer port
of your computer. To print over the network, you must now install a
virtual port, and tell Windows to print over the virtual printer port rather
than the physical port.
1. From the Start button, select Settings and click Printers.
2. In the Printers folder, right-click the Tally T8006 or Tally T8306
printer you just installed and select Properties.
3. In the Printer Properties window, select the Ports tab.
4. Click the Add Port button to open the Printer Ports window.
5. In the Printer Ports window, select Standard TCP/IP Port to start
the Add Standard TCP/IP Printer Port Wizard. Click Next to begin
the Wizard.
6. Enter the IP address. This will also be used as the Port Name of the
printer. Click Next to continue.
7. If the printer was found on the network, the Wizard will display the
network characteristics of the printer. Verify that the settings are cor-
rect and click Finish to complete the Add Standard TCP/IP Printer
Port Wizard.
8. Click Close to close the Printer Ports window.
9. In the Tally T8006 Properties or Tally T8306 Properties window, click
Close to complete the printer port installation.

Configuring Windows to Print on a NetWare Network

The Tally auto-install CD-ROM automatically installs the drivers and
utilities your computer needs to print using NetWare. To print on a
NetWare network, you must have the Novell client installed. If you are
uncertain whether your network settings are correct for printing over the
network, consult your Windows Help or your NetWare operators manual.
Note: To configure NetWare, you must have administrative authority.
Under 3.x you must log in as supervisor and under 4.1x, you must log in as
Admin. To set bindery, you should log in under bindery mode.
Chapter 3 Installing Printer Drivers and Utilities
31