Properties Dialog - Tally T8006 User Manual

Properties Dialog

Using the Properties dialog, you can add or remove network protocols
that the printer will use, and change how the printer uses each protocol.
Note:
Enable only the protocols you need on your network. Activating
additional protocols increases network traffic and can decrease the performance
of other protocols.
To open the Properties dialog:
6. Click the Network Print Server folder, then click the Tally printer you
want to configure.
7. Click the Properties button on the toolbar.
General Properties
Item
Node
Address
Configuration
Password
Internal Printout Destina-
tion
Base URL
Appendix E Network Management
Description
In the factory-set status, a 12-digit
alphanumeric Ethernet address is set
which corresponds to the number on
the label attached to the rear of the
printer.
Access can be restricted by setting a
password in the network interface set-
ting file. If a password is set, that pass-
word must be entered before a user can
change the Property page or Network
window.
When entering a password, enter 'root'
in the name field.
If you forget the password, restore the
network interface settings to the fac-
tory-set default values. Then, perform
setup again.
Even if a password is set, the Property
page and Network window can be
viewed. Use the Users Access Rights
option of the FTP properties page to
prevent the Property page and Network
window from being viewed by users.
This parameter specifies the test page
output destination.
Defines the network interface base
URL. The default is set to http://
www.tally.com.
153