Poor Print Quality - Tally T8006 User Manual

Tally T8006/T8306 Color Laser Printers User Guide

Poor Print Quality

Poor Print Quality
Characters and lines are
faint.
Graphics are partially
blank and/or have light
striping.
Characters and graphics
printed on labels or thick
paper peel off.
Characters and graphics
printed on plain paper are
too glossy.
Characters and graphics
printed on transparencies
are too light or dark when
projected.
100
Poor print quality may be due to various causes. Proceed to the following
problem-and-correction procedures.
Caution! Do not disassemble the printer for further troubleshooting and/
or repair. If the problem is not found and corrected after following these
troubleshooting steps, contact a Tally Service Technician.
Possible Cause
The printer is set to print at
Standard or High-Speed Mode.
The printer is set for Toner
Save.
The Density Adjustment is set
too light.
The wrong paper type is speci-
fied.
The paper is incompatible for
printing.
The paper is too old and/or is
extremely dry.
Multiple sheets of paper over-
lap while printing one sheet.
The toner is depleted.
The OPC belt charging wire is
dirty.
Correction
Set the printer to High-Quality
Mode.
Turn off the Toner Save
(page 52).
Adjust the Density Adjust-
ment to the darker setting
(page 54).
Specify the correct paper type.
Reload the paper tray with the
correct paper type.
Reload the paper tray with
fresh paper.
Make sure multiple pages are
not jammed within the printer.
Replace the toner cartridge(s)
(page 61).
Clean the charging wire
(page 76).