Setting The Opc Belt Counter To Zero - Tally T8006 User Manual

Setting the OPC Belt Counter to Zero

Printer software tracks OPC belt usage. After the counter reaches a pre-
set number, the printer displays a message to indicate that maintenance is
necessary. After the first installation, and after every replacement of the
OPC belt, set the counter to zero.
3. Press either TRAY/
BeltCG.
4. Press MENU/ENTER/ . The display will show Clear BeltCG Not
Execute.
5. Press either TRAY/ or MEDIA/
BeltCG Execute.
6. Press MENU/ENTER/
Execute.
7. Press MENU/ENTER/
BeltCG.
8. Press MENU/ENTER/
Clear BeltCG.
9. Press to exit the Utility Menu and return the printer to normal
operating mode, or turn the power switch off.
Chapter 2 Setting Up Your Printer
1. While pressing the power switch,
press and hold MENU/
ENTER/
Note:
For information about displayed
error messages, see "Appendix D Control
Panel Messages" on page 141.
2. When PLEASE WAIT is dis-
played, release MENU/
ENTER/
show Utility Menu Clear FC.
Roll.
or MEDIA/ until the display shows Clear
until the display shows Clear
. The display will show Clear BeltCG
. The display will show Completed Clear
. The display will show Utility Menu
.
. The display will
19