Removal Of The Log Set - HearthStone Sterling-Ht 8532 Owner's Manual & Installation Manual

HearthStone Quality Home Heating Products Inc
log on the ember burner, in the appropriate
position. It should sit as shown.
2
5) Gently place the Twig Log (3) in the firebox, on
the ember burner and against the Right Log (1).
The twig sits in a recessed part of the ember
burner, which lines it up, in the appropriate
position. It should sit as shown.
6) Open the bag of Platinum Bright Embers. Fluff
up the pieces, and spread randomly over the logs
and burners. These embers will glow brightly
when the unit is running.
7) Re-install the glass assembly by lining up the
three tabs on the bottom of the assembly with
the three slots on the firebox. Slide the lower
portion of the glass assembly into the slots and
push it flush against the firebox. Rotate the clips
into the "locked" position. Re-install the front
cast by sliding the upper portion under the lip of
the top and tilting the bottom in flush with the
glass assembly. It should then slide downward
and be snug in place.
assembly is properly secured to the firebox
before turning the unit on. Be careful not to chip
the enamel when installing the glass assembly or
front cast.
3
Make sure the glass
STERLING Ht Gas-Fired Direct Vent heater
R
EMOVAL OF THE
Caution
Log set retains heat and can be very hot, if
previously lit! Allow 1 hour after pilot light is turned
off before handling.
To remove the log set, follow the Installation of
Log Set instructions in reverse.
in a safe area where they will not be damaged.
C
AUTION
Fragile! Handle log set with care.
18
L S
OG ET
Place the logs and