Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc.
5.
Gently slide the shortest of the "half" logs (3)
onto pin B as shown below.
6.
Gently slide the medium length of the "half"
logs (4) onto pin E as shown below.
7.
Gently slide the long unbroken log (5) onto
pins C and D as shown below.
SANTA FE 8761 Gas-Fired Direct Vent Heater
8.
Spread evenly across the front portion of the
Pan Burner, one layer high, the Charcoal Embers.
You may or may not need to use all of the Charcoal
Embers. Keep the rest for use in the future. Locate
and open the bag of Platinum Bright Embers. Pull
apart small pieces of the wool and sprinkle over the
Charcoal Embers randomly. This wool will glow
brightly once the unit is running.
9.
Attach the façade to the firebox. Make sure
the glass assembly and facade are properly secured
to the firebox before lighting the unit. Be careful not
to chip the enamel when attaching the components.
R
L
EMOVAL OF
OG
CAUTION! LOG SET AND CHARCOAL EMBERS
WILL RETAIN HEAT AND CAN BE VERY HOT, IF
PREVIOUSLY LIT! ALLOW AT LEAST 1 HOUR
FOR COOLING AFTER PILOT LIGHT IS OFF
BEFORE HANDLING.
To remove the log set, follow the Installation of Log
Set instructions in the reverse order.
CAUTION! FRAGILE! HANDLE LOG SET AND
CHARCOAL EMBERS WITH CARE.
S
ET
Page 18 of 31
Advertisement
Table of Contents
