Firebox/Log Set Placement; Installation - HearthStone Champlain Owner's Manual

Gas-fired direct vent heater
Hide thumbs Also See for Champlain:
Table of Contents

Advertisement

Hearthstone Quality Home Heating Products, Inc.
WARNING
Absolutely no leakage should occur, otherwise
there is a danger of fire or explosion depending upon
conditions. Never use if leakage is detected.
Log Set Placement
CAUTION: FRAGILE! HANDLE LOG SET WITH
CARE. ALWAYS WEAR GLOVES AND SAFETY
GOGGLES WHILE HANDLING THE LOG SET.
WARNING: FAILURE TO POSITION THE PARTS IN
ACCORDANCE WITH THESE DIAGRAMS OR
FAILURE TO USE ONLY PARTS SPECIFICALLY
APPROVED WITH THIS APPLIANCE MAY RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY.
AVERTISSEMENT. RISQUE DE DOMMAGES OU DE
BLESSURES SI LES PIÈCES NE SONT PAS
INSTALLÉES CONFORMÉMENT À CES SCHÉMAS
ET OU SI DES PIÈCES AUTRES QUE CELLES
SPÉCIFIQUEMENT
APPAREIL SONT UTILISÉES.
Place only the ceramic log set supplied with the unit
in the firebox. Do not place any other ceramic logs,
wood logs, or other materials in the firebox. If the log
set is damaged or broken contact your dealer for
replacement. The ceramic logs will last a long time;
however, they will break if subjected to rough or
improper handling. Exact positioning of the log set is
required in order to obtain a pleasing flame pattern
and efficient combustion. Incorrect log placement
may cause carbon build-up; excess thermal stress on
the log set and stove parts, reduced efficiency, and
high levels of carbon monoxide. Position the log set
exactly as shown in order to obtain a pleasing flame
pattern and efficient combustion. Incorrect log
placement can cause carbon build-up; excess
thermal stress on the log set and stove parts, reduced
efficiency, and high levels of carbon monoxide. If the
log set does not fit into the firebox exactly as outlined,
contact your dealer for assistance.
Installation of the Log Set
CAUTION: DO NOT PLACE EMBERS NEAR THE
PILOT.
(Refer to the figures in this section)
1. If not already opened, follow the instructions for
firebox access on page 8.
2. Remove the packaging material around the log
set assembly. Be careful not to damage the log
APPROUVÉES
AVEC
set when unpacking. Observe the 5 mounting
"posts", A, B, C, D, and E.
3. Gently slide the Y-shaped Log (1) onto pins A and
C, as shown next.
CET
4. Gently slide the longer, "half" log (2) onto pin D.
Be sure to position the rear of the log in front of
the pilot assembly and against the left side of the
firebox as shown below.
CHAMPLAIN Model 8304
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

8304

Table of Contents