Attaching Your Venting - HearthStone Sterling-Ht 8532 Owner's Manual & Installation Manual

Hearthstone Quality Home Heating Products, Inc
A Y
TTACHING OUR
Follow the instructions in either of the 5"x8"
starter kits. If you are attaching the Top Exit kit,
(#95-60320) for vertical venting configurations,
the instructions will be provided with the kit.
I C :
NNER OLLAR
Locate the 8 screw holes where the inner collar
attaches to the heat exchanger. Attach the inner
collar and gasket with the 8 screws provided
with the collar.
O C :
UTER OLLAR
Locate the 8 screw holes where the outer collar
attaches to the heat exchanger. Attach the outer
collar and gasket with the 8 screws provided
with the collar.
You are now ready to install your venting.
1. Gasket
2. Inner Starter
3. Gasket
4. Outer Starter
V
ENT RESTRICTOR
When converting the unit to a top exit, (4"x6"
pipe), a restrictor is supplied with the kit.
Instructions for installation of the restrictor are
supplied with the kit. To adjust your restrictor
for maximum flame appearance, first ensure the
unit is cool before touching any part of the stove
or venting. Refer to the Venting Configurations
for recommended restriction plate positions.
V
ENTING
Loosen the Phillips head screw and rotate the
locator, found on the rear middle of the stove to
a position which corresponds to the appropriate
chart setting. Shown below are the approximate
locations of the settings 1-3; however it can be
set in any position. Tighten the screw in the
desired setting.
These positions are based on lab results and can
have some variance.
IF the vent-air intake system is disassembled for
any reason, reinstall per the instruction provided
for the initial installation.
The flow of combustion and ventilation air
must not be obstructed.
Restrictor Plate Setting Locations
15
STERLING-Ht Model 8532
Note: