Control Feature; Key Switch; Manual Choke Knob - E-TON ROVER Owner's Manual

Key Switch

A - OFF Position - With key in off position,all
switched power is off,and engine should not
run.
B - ON Position - Turn key from off to the position
and all switched power circuits will be energized.
C - START Position - Turn key to start position
to start the engine .Release key after engine
has started and it will automatically return to
the on position.
The engine will continue to run.
Only For ROVER
This vehicle is equipped with a long key and a
short key.
A limited speed with Max 7 mile is controled by
the short key.
A limited speed is controled by the long key and
(C.D.I.) with 4different kind of speed.(9.3,12.4,
15.5 & 18.6 mile)
C.D.I is located in front cargo box.
NOTE: Your unit includes an electronic speed
control (C.D.I) that is set to limit the maximum
speed of the unit to the standards set by the
CPSC for the age of the rider the unit was
designed for.
Copyright ©2008-2009 ETON America, all rights reserved.

CONTROL FEATURE

CONTROL FEATURE
The vehicle are equipped with a manually
operated carburetor choke system.
This choke is operated by the knob at the
left side of the dashboard.
The engine choke knob is used to enrich
the fuel mixture when starting the engine
from a cold start.
When first starting the engine,(cold start),
place the knob in the full up position,(Choke
closed or on) After allowing the engine to
warm up for 15-20 seconds, slowly move
the knob back to the normal until the engine
idles down runs smooth.The knob to the full
down is the normal operation position.(Choke
open or off).
Page 9
Manual Chocke Knob