Table of Contents
Advertisement
User Configurations {CLNd}, {IPan}, {ItLt}, {Irot}-606DBR, {IdIN}
All of the fixtures have three user selectable run-time configurations that change the behavior of a certain
function. The three functions are described below.
CO L O R MO DE {CL ND}
This mode allows you to select whether your controller will access the color palettes in solid colors only or
solid and split colors.
1)
Tap the MENU button until the display reads {CLNd}.
2)
Press the ENTER button to select this function. The selection is confirmed when the display begins to
blink. You must make a selection within 8 seconds.
3)
Press the UP and DOWN buttons to toggle between the {SC} for split colors and {no} for no split
colors.
4)
Press the ENTER button to activate selection.
PAN I NVERT {I PAN } – T ILT I NVERT {IT LT } – {I RO T }
It is possible to invert the pan and tilt mirror movement from within the fixture itself. This could be helpful in
situations where the positioning or rigging of a fixture led to a reverse orientation of the fixture in relation to
all or most other fixtures installed. When choosing to command the pan or tilt of all fixtures at the same
time you will notice that the fixtures whose orientation is different from the others will most likely move
opposite of the rest. You can apply a pan and tilt Invert by following these instructions.
1)
Tap the MENU button until the display reads {IPan} or {ItLt}.
2)
Press the ENTER button to select this function. The selection is confirmed when the display begins to
blink. You must make a selection within 8 seconds.
3)
Press the UP and DOWN buttons to toggle between the {I} for inverse and {no} for none.
4)
Press the ENTER button to activate selection.
5)
Note! For the 606DBR Barrel Scan, the {ItLt} function is replaced with {Irot} which reverses the
rotation of the Barrel mirror instead.
Segment Display Configurations {Led}, {IdSP}
The LED segment display can be set to off after 8 seconds of no menu activity. The LED will display again
as soon as the menu is accessed by pressing any of the buttons. The display can also be inverted making
it easier to read the menu depending on the orientation of your fixture.
T URNI NG T HE DI SPL AY O FF {L ED}
1)
Tap the MENU button until the display reads {Led}.
2)
Press the ENTER button to select this function. The selection is confirmed when the display begins to
blink. You must make a selection within 8 seconds.
3)
Press the UP and DOWN buttons to toggle between the {on} and {off} setting.
4)
Press the ENTER button to activate selection.
5)
Note! This configuration is set on an individual fixture basis.
DI SPL AY I NVERSE {I DSP}
1)
Tap the MENU button until the display reads {IdSP}.
2)
Unlike in other instructions, pressing the ENTER button will toggle between { IdSP} for normal and
{dSPI} for reversed.
ILS-606 & ILS-625 User Manual
11
Operating Instructions
2005-03-09/22:45
Advertisement
Table of Contents
