8.4 ACCESSORY CABLE
Wire Color/Description
WHITE - External Speaker ( + )
SHIELD - External Speaker (–)
BLUE- NMEA Input (+)
GREEN - NMEA Input (–)
PURPLE - NMEA Output (+)
When connecting the external speaker or GPS navigation receiver, strip off
about 1 inch (2.5 cm) of the specified wire's insulation, then splice the ends
together using proper waterproofing techniques.
•
The GPS must have the NMEA Output turned on and set to 4800 Baud in
the setup menu. If there is a selection for parity select none.
•
For further information on interfacing /setting up your GPS. Please contact
the manufacturer of the GPS receiver.
•
GX1100S can read NMEA-0183 version 2.0 or higher.
•
The NMEA supported sentences are:
Input:
GLL, GGA, RMC and GNS (RMC sentence is recommended)
Output: DSC and DSE
(DSC sentences to Standard Horizon Plotter for Position Polling)
8.5 CHECKING GPS CONNECTIONS
After connections have been made between the
GX1100S and the GPS, a small satellite icon will ap-
pear on the top right corner of the display, and dis-
plays your current location (Latitude/Longitude) on the
display.
If there is a problem with the NMEA input from a GPS, the GPS icon will
blink continuously until the connection is corrected.
GX1100S
Connection Examples
Connect to external 4 Ohm audio speaker
Connect to external 4 Ohm audio speaker
Connect to NMEA (+) output of GPS
Connect to NMEA ground of GPS
Connect to NMEA ( + ) input of GPS
Shield
White
NMEA OUT
Blue
Green
NMEA OUT
Purple
NMEA IN
NOTE
PA Speaker
GPS Receiver
( )
( )
( )
Page 13