Standard Horizon Eclipse DSC+ GX1100S Owner's Manual page 18

KEYPAD
[ ( UP )] / [ ( DOWN )] KEYS
The [ ( UP )] and [ ( DOWN )] keys are used to select a desired chan-
nel and to select items in the DSC OPERATION and SETUP menus.
[ 16/9 ] Key
Immediately recalls channel 16 from any channel location and automati-
cally selects high power. Holding down this key recalls channel 9. Press-
ing the [ 16/9 ] key again reverts to the previous selected working channel.
Secondary use
Press and hold the [ 16/9 ] key then press the [ CLR ( WX )] key to switch
between the USA, Canadian, and International Channel Groups.
[ SCAN ( MEM )] Key
Press this key to start and stop the scanning of programmed channels.
Refer to section "8.10 SCANNING" for details.
Secondary use
To add a channel into the scan memory, select the channel and press
and hold the [ SCAN ( MEM )] key until "MEM" is shown on the display.
To delete a memorized channel from scan memory, select the channel
and press and hold the [ SCAN ( MEM )] key until "MEM" is removed from
the display.
[ DISTRESS ] Key
Used to send a DSC Distress Call. To send the distress call refer to section
"9.3.1 (Transmitting A Distress Alert)."
DC INPUT CABLE
Connects the radio to a DC power supply capable of delivering 12V DC.
EXTERNAL SPEAKER CONNECTION CABLE
Connects the GX1100S to an external speaker.
GPS RECEIVER CONNECTION CABLE
Connects the GX1100S to a GPS receiver.
GND TERMINAL
Connects the GX1100S to a good ground, for safety and optimum perfor-
mance.
Normally, the GND connection to the heat sink is not needed. However,
when the DC power cable connection to the radio has a long run, the trans-
mitter may become unstable and the receiving audio may be noisy. In such
a case, connect a large diameter, short cable between this terminal on the
heat sink and battery ground.
Page 18 GX1100S