alarm sound and the position from the polled
vessel transferred to the GPS Chart plotter.
10. Press any key to stop the alarm.
11. Press the [ ( DOWN )] key to show the po-
sition from the polled vessel transferred on the dis-
play.
12. If the GX1100S does not receive a reply, the dis-
play will be as shown in the illustration on the right.
To send again, press the [ ENT ] key.
11.8.3 Receiving a Position Request
When a position request call is received from another vessel, a ringing alarm
will sound and POS REQUEST will be shown in the LCD. Operation and trans-
ceiver function differs depending on "POS REPLY
setting.
Automatically reply:
1. When a position request call is received, a calling
alarm sounds 5 times. Then requested position co-
ordinates are transmitted automatically to the ves-
sel requesting your vessels position.
2. To exit from position request display, press the [ CLR ] key.
Manually reply:
1. When a position request call is received from an-
other vessel, the GX1100S will produce a ringing
alarm sound and the LCD will be as shown in the
illustration at the right.
2. Press any key to stop the alarm.
3. Press the [ ENT ] key to send your position to the requesting vessel, or press
the [ CLR ( WX )] key.
4. To exit from position request display, press the [ 16/9 ] key.
GX1100S
POS REPLY" in the "DSC SETUP
POS REPLY
POS REPLY
POS REPLY
DSC SETUP" menu
DSC SETUP
DSC SETUP
DSC SETUP
Page 51