Standard Horizon Eclipse DSC+ GX1100S Owner's Manual page 39

Manual Calling
You may enter an MMSI number manually to contact without storing it in the
Individual Directory.
1. Press the [ CALL ( MENU )] key. The "DSC MENU
will appear.
2. Press the [
INDIVIDUAL". (To cancel, press the [ 16/9 ] or
"INDIVIDUAL
INDIVIDUAL INDIVIDUAL
INDIVIDUAL
[ CLR ( WX )] key.)
3. Press the [ ENT ] key. The transceiver will beep,
and the "Individual directory" will appear.
4. Press the [
MANUAL", then press the [ ENT ] key.
"MANUAL
MANUAL MANUAL
MANUAL
5. Press the [
through numbers, 0-9. To enter the desired num-
ber and move one space to the right, press the
[ ENT ] key. Repeat this procedure until all nine
spaces of the MMSI number which you want to
contact are entered.
6. If a mistake was made entering in the MMSI num-
ber repeat pressing the microphone's [ H/L ] key until
the wrong number is selected, then move the chan-
nel knob to correct the entry.
7. When finished entering the MMSI number, press
and hold the [ ENT ] key.
8. Press the [ ENT ] key, then press the [
[ ( DOWN )] keys to select the operating channel you
want to communicate on and press the [ ENT ] key.
9. Press the [ ENT ] key again to transmit the individual
DSC signal.
10. After the INDIVIDUAL CALL is transmitted, if a reply
signal is not received, "WAIT FOR ACK
show on the display. To send the call again, press
the [ ( DOWN )] key followed by the [ ENT ] key.
11. When an individual call acknowledgment is re-
ceived, the established channel is automatically
changed to the channel which is selected on step
8 above and a ringing tone sounds.
12. Press the [ CLR ( WX )] key to listen to the channel
to make sure it is not busy, then key the micro-
phone and call the other vessel you desire to communicate with.
GX1100S
( UP )] / [ ( DOWN )] keys to select
( UP )] / [ ( DOWN )] keys to select
( UP )] / [ ( DOWN )] keys to scroll
WAIT FOR ACK" notation will
WAIT FOR ACK WAIT FOR ACK
WAIT FOR ACK
DSC MENU DSC MENU" DSC MENU
DSC MENU
( UP )] /
Page 39