Printer Maintenance Mode - Muratec MFX-1600 Field Engineering Manual

3.8 Printer maintenance mode

In case of followings, use this mode.
When replaced the Fuser unit or Transfer roller.
When "Please Call Service" message appear in the LCD, access this mode to determine the cause of
the "Please Call Service" error message.
Y
When you replace the Fuser unit or Transfer roller, you must set the count of replacement
manually
To access the printer maintenance modes:
Note:
Do not set the these counters if you did not replace the Fuser unit or Transfer roller.
1. Press Program key, *, 6.
The mode is contained within two main menu level.
Set Replace Counter
/ /Enter
Service Call
/ /Enter
2. Press until "Set replace counter" appears in the LCD and then press ENTER.
3. The LCD shows:
Replace Fuser
/ /Enter
4. If you replaced the fuser unit, press ENTER and then skip to step 7.
5. If you replaced the transfer roller, press
The LCD shows:
Replace Transfer
/ /Enter
6. Press ENTER.
7. Press STOP to exit this mode.
Y
When "Please Call Service" message is displayed in the LCD
To access the printer maintenance modes for determine the cause of the "Please Call Service" error
message.
1. Press Program key, *, 6.
The mode is contained within two main menu level.
Set Replace Counter
/ /Enter
Service Call
/ /Enter
2. Press until "Service Call" appears in the LCD and then press ENTER.
.
3-61