Machine Parameter B:4; Machine Parameter B:5 - Muratec MFX-1600 Field Engineering Manual

Machine Parameter B:1
Initial
Switch
Setting
7 0 Leading edge document
margin adjustment
6 1
(ADF)
5 0
4 0
Adjusts the leading edge
3 0
margin from the mirror
2 0
carriage passes End Sensor
1 0
to the start of the scanning
0 1
position.
Each setting changes
by 0.85mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Machine Parameter B:2
Initial
Switch
Setting
7 0 ADF scanner registration
adjustment (Horizontal)
6 0
5 0
Adjusts the start point to scan
4 0
the document.
3 0
The plus setting increase the
2 0
left margin and the minus
1 0
setting decrease it.
0 0
Each setting changes by
0.5 mm.
Adjust
Switch 76543210
Adjust
Switch 76543210
3-8
Usage/Comments
Settings
00000000 0.00 mm
00000001 0.85 mm
00111100 51.00 mm
00111101 51.85 mm
00111110 52.70 mm
00111111 53.55 mm
01000000 54.40 mm
01000001 55.25 mm
01000010 56.10 mm
01000011 56.95 mm
01000100 57.80 mm
01000101 58.65 mm
01000111 59.50 mm
11111111 216.75 mm
Usage/Comments
Settings
00000111 3.5 mm
00000110 3.0 mm
00000101 2.5 mm
00000100 2.0 mm
00000011 1.5 mm
00000010 1.0 mm
00000001 0.5 mm
00000000 Initial setting
10000001 -0.5 mm
10000010 -1.0 mm
10000011 -1.5 mm
10000100 -2.0 mm
10000101 -2.5 mm
10000110 -3.0 mm
10000111 -3.5 mm
Initial setting
Maximum
Minimum