Muratec MFX-1600 Field Engineering Manual page 123

What you see on the LCD
Too Many Characters
Too Many Locations
Too Many Steps
Unable to Reduce
Use FBS Glass
Select Paper Size
What it means/ What to do
You attempted to enter too many numbers or other characters in the current
operation.
Press CANCEL to delete the extra characters, then try again. You may wish
to review the operation's appropriate instructions.
You tried to enter too many numbers for a broadcast. You can enter up to
200 autodialer numbers and up to 30 numbers entered through the numeric
keypad.
Press CANCEL to delete the extra numbers and then try again.
You tried to enter too many steps for a macro. You can enter up to 60 steps
into a macro key.
In the reduction copy using the ADF, if the calculated ratio is smaller than
minimum reduction ratio (50%), this message will appear and you cannot
make the reduction copy.
Use the FBS glass, however parts of the image might not be copied.
You tried to enlargement copy using the ADF. Your machine cannot
enlargement copy from the ADF.
Please set your document on the FBS glass to make the enlargement copy.
You tried to make a copy in the following conditions:
• Paper size selection is set to "Auto".
• The bypass tray has the paper other than A4, A5 or F4.
• Paper cassette(s) runs out of paper.
Press PAPER SIZE to select your desired paper.
4-17