Table of Contents
Advertisement
Mark IP Type Of Service
Mark 802.1p if 802.1q is
enabled on WAN
SET-1
Physical LAN Port
Protocol
Source IP Address
Source Subnet Mask
UDP/TCP Source Port (port or
port:port)
Destination IP address
Destination Subnet Mask
UDP/TCP Destination port (port
or port:port)
SET-2
802.1p Priority
If the Enable Differentiated Service Configuration checkbox
some additional fields will display, as shown below.
The additional Items are explained here.
Normal Service, Minimize Cost, Maximize
Reliability, Maximize Throughput, Minimize Delay
Select between 0-7. The higher the digit shows
the higher the priority.
Select between ENET(1-4) and USB
TCP, TCP/UDP, UDP, or ICMP.
Enter the source IP address.
Enter the subnet mask for the source IP address.
Enter source port number or port range.
Enter destination IP address.
Enter destination subnet mask.
Enter destination port number or port range.
Select between 0-7. The lower the digit shows
the higher the priority
58
is selected,
Hide quick links:
Advertisement
Table of Contents
