Table of Contents
Advertisement
Enable WAN Service
Tick the checkbox
Service Name: This is the WAN Service label.
STEP 6: Upon completion, click Next. The following screen appears.
This screen allows for the configuration of the CT-5361T LAN interface IP address,
subnet mask and DHCP server. To auto-assign IP addresses, DNS server and
default gateway to other LAN devices, select the Enable DHCP server radio box.
You must also enter the start and end IP address and DHCP leased time.
NOTE:
LAN interfaces (e.g. USB and Ethernet) share the same subnet since they
are bridged within the router.
Select Enable DHCP Server Relay (if required), and enter the DHCP Server IP
Address. This allows the router to relay the DHCP packets to the remote DHCP
server. The remote DHCP server will provide the IP address.
NOTE:
Enable DHCP Server Relay will not display if NAT is enabled.
To configure a secondary IP address for the LAN port, click the checkbox
to enable the WAN service.
25
shown.
Hide quick links:
Advertisement
Table of Contents
