DHCP MODE
Set your PC to DHCP mode by selecting Obtain an IP address automatically in
the Internet Protocol Properties dialog box, as shown below.
3.3 Login Procedure
Perform the following steps to login to the web user interface.
NOTE:
The default settings can be found in
STEP 1: Start the Internet browser and enter the default IP address for the device
in the Web address field. For example, if the default IP address is
192.168.1.1, type
NOTE:
For local administration (i.e. LAN access), the PC running the browser
must be attached to the Ethernet, and not necessarily to the device. For
remote access (i.e. WAN), use the IP address shown on the
WAN
screen and login with remote username and password.
STEP 2: A dialog box will appear, such as the one below. Enter a default
username and password, as defined in section
3.1 Default
http://192.168.1.1.
17
Settings.
Device Info -
3.1 Default
Settings.